Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all seniors,
I am facing a problem with measureing maximum value of a trace in LTspice. how i can run the .mean command for that trance names as "Output".
and secondly .step command is used to get the trace "Output" for different resistor values. there are 10 traces for 10 different...
thank you for sharing your knowledge. For the PCB layout i would do the same upper and lower most ground and between two layers would hold the circuit.
In my case phase detector would always be out of phase. does it work for 100m peak to peak sine signals with offset 60mV.
i have a RC...
could you please draw schematic for your requirement that case i would be able to help you. with voltage controlled current source or constant current source. or other way is : to do so just calculate simple resistor value to allow 330mA for each string. you need a resistor of around 29 ohms.
Hi to all,
any one have used AD8392 or any Phase and detector IC? any idea?
https://www.analog.com/media/en/technical-documentation/data-sheets/AD8302.pdf
i am having problem in using these kind of ICs.
Regards
Bilal Ahmad
thanks for replying.
i am using one example from atmelstudio to generate sine wave.
uint32_t dac_val = 0;
dacc_write_conversion_data(DACC_BASE, dac_val);
this method convert data for dac output. by putting dac_val = 0; it generate constant voltages around 500mV offset. this shows that dac...
Hi seniors,
I am using DAC of Microcontroller (SAM4S 32-bit) to generate Sine wave, my problem is that the output sine wave have offset about 500mV that i do not want and there may be another way to adjust it. but can i adjust the offset by using op amp? sine wave is 100mV peak to peak and with...
thank you sunnyskyguy you really helped me. now i understand whats really going on.
- - - Updated - - -
Thanks schmitt trigger it really helped. now i have idea how to get Analogue voltages from 4060 counter. i have bought the 4060 chip and mcp6002 op amp. i want to measure phase diff at the...
hey thanks sunnyskyguy for helping me. as i am new to these topics, i did not get it fully. XOR gate mixer with steady frequency. but the output will be the Rail to rail of XOR gate. isn't is? in the case when i only use XOR gate as a mixer?
and i want to measure the phase difference from 0 to...
Hi,
My problem is to calculate the phase difference. sine wave was with frequency 10KHz and amplitude is 100mV. Resistor and capacitor are in series. Due to the capacitor there is a phase difference and that can also be seen in the simulation that i uploaded. How i can use 4046 IC or any other...
Hi, i need to make a Pspice part for simulation. the Maker company only gives this data.
*Jun 01, 2010 *Doc. ID: 90412, Rev. A *File Name: part irfl9014_PS.txt and part irfl9014_PS.spi *This document is intended as a SPICE modeling guideline and does not *constitute a commercial product data...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
