Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
what do you mean by capacitor doesn't work at 24V?
I thought that maybe it's value is to low so the charge is not sufficient to provide enough current to trigger TRIAC.
Do you perhaps have some suggestion?
Hi guys,
I am having problem with triac conducting.
In attached schematics triac should control current through R1 by turning potentiometer. I found somewhere on the net schematics and i thought it will work, I dont have to much experience with TRIACs so i would like to hear youw suggestions...
7915 is connected corretly, i know for the different pinout. And diode is correctly connected, polarity is same as in picture :(
I tested this configuration on breadboard and it worked :/ maybe it is worng layout on PBC, i will double check it ;)
hello!
I have problem with output on this circuit :/
I'm getting -20 volts on negative side while positive side give me 15 volts, so i could use some help to solve it :)
hi!
I need 18 volts supply, since i'm having 12 volts transformer i decided to use full wave voltage doubler to raise voltage to 24 volts.
But at the output of doubler i'm getting 36 volts :/ and after pluging it to LM7818 at the output of regulator i'm getting 3.5 volts :(
In datasheet of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.