Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by amjad

  1. A

    What are the back drilled vias?

    Re: Back drilled vias back drill
  2. A

    How can I generate the IPC356A files from PCAD2002?

    Hi, How can i generate the IPC356A files from PCAD2002? Regards, Amjad
  3. A

    Looking for book: Microvias: For Low Cost, High Density Interconnects

    I require following ebook urgently Microvias: For Low Cost, High Density Interconnects John H. Lau,S.W. Ricky Lee Publisher: McGraw-Hill Companies, ISBN: 0071363270
  4. A

    Pads2005 SP2 installation probelm

    pads 2005 install Hi While insalling SP2 over pads 2005 SP! i am facing errors . Did any one successfully installed?. Please tell me how to install.
  5. A

    How to change the net name in PADS 2005?

    PADS 2005 help Hi anyone can explain how to install pads2005 sp2. I already installed Pads 2005 sp1 ,but while installing sp2 it gives error.
  6. A

    Steps of flip drill process

    Could you please give me an outline on flip drill process?
  7. A

    Can we export concept hdl schematic to pads netlist ?

    Can we export concept hdl schematic to pads netlist ? thanks in advance
  8. A

    Importing DXF file to Allegro Board File

    import dxf .cnv file allegro when importing DXF file, you will enable the " incremental addition"
  9. A

    IPC-D-356A file in PROTEL 99SE ?

    Thank you so much House_Cat!.
  10. A

    Negative artwork problem in Allegro 15.2

    In Allegro 15.2, if plane is set as negative in design, how to generate artwork as negative plane? Selecting negative option while generating artwork creates gerbers. But, the data comes as 3 splitted layers if imported in cam. Converting this to composite layer doesn't provide correct data...
  11. A

    IPC-D-356A file in PROTEL 99SE ?

    protel99se ipc Is there any way to generate IPC-D-356A file in PROTEL 99SE? Can anyone answer pleease. Thanks.
  12. A

    Mentor layout tool doesn detect Vcc and GND mistakes

    Mentor problem Can any one help me in doing backannotation in Design capture schematic for nets routed as bestfit in Expedition PCB version 2002 design?
  13. A

    Looking for IPC 600 A standards

    Can anyone has the IPC 600 A document ?
  14. A

    Any Protel expert willing to help?

    I am telling this again more elaborately which is applicable for PROTEL 99SE and also for PROTEL 2004. To update a footprint in the layout, In the pcb layout menu Design->Make library (layout library not schematic library) and then select the footprint in BrowsePCBLib tab. Edit the required...
  15. A

    Any Protel expert willing to help?

    To update a footprint in the layout, Design->Make library and then select the footprint in BrowsePCBLib. Edit the required change and then click UpdatePCB button. That's all. To update the height/width of all designators, Select a designator by double clicking it. In the properties dialog...
See more

Part and Inventory Search

Back
Top