Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi All,
I have 9-year experiences at pcb layout which can be done by Mentor-PADS, Mentor-WG, Cadence-Allegro, Cadence-Orcad Layout, Altium, or even Eagle Editor. Pls feel free to contact me via alex.epds@gmail.com.
And I also deal in buying parts, fabrication and assembly. I am located in...
Dx designer to pads 2007
You probably have to convert the Dx designer to powerlogic first, then from powerlogic to PADS2007. If you need help to convert it. Pls feel free to send me the dx design file.
*.asc format pads
It's better to export the PADS file with .asc format in 3.0version. And after you import the .asc file into Allegro, you have to edit the plane layers and the coppers on signal layers.
pads convert
You might need to convert Ealge to Protel first, then
if you have PADS2005 version, there will be a convert tool to convert protel to pads
PCB Design Service
Hi All,
I want a part time job to do pcb layout, anyone who need the layout service, pls
feel free sent email to me. I will reply you on time. I am good at pcb layout, and have almost 6 years experience. The tools I am using for layout are:
Schematic: Orcad capture...
cadsoft eagle rf track width
I need a ulp file to convert the eagle brd to protel pcb, I already have one , but it's for 4.16 version,
I need a higher version. Thanks,
Added after 6 minutes:
Hi friends, I was using 4.16version, and it's good for layout. However, after the software was...
pcb layout part time job
Hi All,
I want a part time job to do pcb layout, anyone who need the layout service, pls
feel free sent email to me. I will reply you on time. I am good at pcb layout, and have almost 6 years experience. The tools I am using for layout are:
Schematic: Orcad capture...
You can set the rule in allegro or specctra, I think allegro is fine, because when you back to allegro from specctra, you still can find the rule in allegro.
cam350 nc table import
Why cann't you input the drill database? If you use" File---import---autoImport,
it should input the gerber files automaticlly, if you cann't got the right graphic with drill , pls check the format and acuaccy, and then, when you re-import the gerber file, pls select...
Re: PADs CAM
That should be crazy, you don't want the trace routing on layer 2 & 3, at the same time you want to remove the dot in layer 2 & layer 3, it's impossible, the non-function pad should be remove when cam . If you use via1-4, that should be cause a short that the trace will connect to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.