Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i want someone to design and develop a PCB compossed of Sim300dz and Atmega32l (atmel) connected togather with load at atmega32's output.
The purpose is to use sim300dz as a module to send and recieve text message and further pass the message information to microcontroller(atmega32l...
Hi everyone i decided to do a Home automation system using sim300dz module.
i ordered my parts through Farnell website. and after recieving my parts facing many difficulties.
i) sim300dz is surface mount Module. How can i physically connect it if i will design PCB for the project?
ii) Farnell...
thanks for this useful information "alexan_e"
but my main problem is the usage of AT commands for the GPRS module (Sim300dz). which are as follows....
can you please show me 1 example of how to use At command in C.
my main idea is to develop home automation system using GSM.
if i send a message...
i have to make a C programme for atmega32L which enables me to communicate with sim300DZ and respond accordingly to the load circuit which will be attached to output of atmega32L. but i am not very good at C programming and i have designed a program which switches ON and OFF 2 LEDs. can you...
can you please tell me how much it will cost??? and was it sim300dz(surface mount) module which you bought? and is there ant PCB module of Sim300dz available? please let me know it will be a great help!!
---------- Post added at 22:14 ---------- Previous post was at 21:22 ----------
badar if...
hi.
i know my question is irrelivent but i just wana ask you can you help me where you bought accesories for sim300dz? i mean i ordered sim300dz online and they just sent me only sim300dz itself no RF antenna no sim holder and i need both of them compulsory can you please help me if you know...
I have choosed microcontroller chip (32L AVR) to use as controller for the load circuit and for the interface to sim300DZ.
32L AVR has 4 I/O bidirectionals ports with a reset pin as well. i am thinkng to connect AC load so i have to use relay to behave as a switch which will switch ON or OFF...
Here i am thinking to develop a project of Home Automation using Sim300z by creating control Through Microcontroller.
but i am just a beginner i dont have any clue about it.
i will really appreciate if anyone of you expert can help me just starting up with this idea.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
