Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi everybody!!!
i have designed a wilkinson Power divider in ADS,
in the schemetic it is working best but when i generate layout,
i have no idea how to place shunt resistors(lumped element in case of schematic) between the microstrip lines. ..
when i calculate W and L for equalenct value for...
ads layout simulation
hi evrybody!!
what shud i do to remove the following WARNING. which shows like this:
"S-Parameter simulation
WARNING: S-parameter result show unphysical behaviour for certain frequencies.
CAUSE:
1. inaccurate (high frequency) calibration
2. higher order modes at...
ADS layout editing
i was wondering if somebody tell that is there some type of cutting tool in ADS-layoout,
i want to draw first a rectangle and then want to cut its some portion for tunning..
can u help me out?
ADS layout editing...
hi every body!!
can any one tell, how can i cut some portion of transmission line in the layout,
i want to cut (remove) edges/corners of a rectangular stripline ...
shape is:
____________
|___________|
and i want
/--------------\
\__________/
i'm using ADS 2004A...
ads layout site:edaboard.com
hi,
i have made schematic for power divider, it's working (response ) is the best.
but
when i generated layout, and executed the EM analysis, i noted that layout is ignoring the effect of all the shunt resistors used.
i want design on microstripline,
can...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.