Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

ADS layout simulation-error

Status
Not open for further replies.

accountme05

Newbie level 5
Joined
Feb 17, 2009
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,347
ads layout simulation

hi evrybody!!

what shud i do to remove the following WARNING. which shows like this:

"S-Parameter simulation
WARNING: S-parameter result show unphysical behaviour for certain frequencies.

CAUSE:
1. inaccurate (high frequency) calibration
2. higher order modes at the ports.
3. slot mode at coplaner ports
4. grouped strip-slot ports
5. too coarse of mesh "

thanx!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top