Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for your reply, Tomhive.
Is it possible to measure the S2P file of only one antenna?
Because in HFSS, if we use multi-port to excite the antenna, then we can get the SNP file. Also I think we can use the same scheme to get the S2P file of a single antenna.
Can you give me some...
Hello, All,
I want to ask if we can measure and export the S2p file of antenna by using the network analyzer.
I know somebody can do it. But I don't know how they set up the test bench.
Because the antenna only has one port, to measure the S2P, I think we have to regard the antenna...
Thank you very much for your reply.
Actually at present, I don't care how much the efficiency of the antenna is dropped. My target is improving the bandwidth of the antenna.
I am quite new in the field of antenna. Would you please give me some reference about the relationship between the...
Hello Everyone,
I want to ask if there is any relation between S11 and S21 for the antenna. Usually we take the antenna as one port device. But If we take the feed port of antenna as one port, and the radiation port of antenna as another port, the antenna becomes two-port device. In this...
Hello, Everyone,
I want to ask if I can reduce the Q value of the antenna. Because usually for the narrowband antenna, it has quite high Q value (I think it should be larger than 20, some maybe 40 or 60).
Now I want to reduce the Q value of the antenna, and further increase the antenna...
Re: HFSS: help on 10G XFP CONNECTOR SI simulationᦀ
I also have the same problem. I try to simulate a dipole antenna using differential lump port, but it is always has the error, then I have to delete one terminal, then it can work.
Anybody can explain the reason?
Greatly appreciate!
Hi, All,
I am a student in the field of RF circuit design. Now I want add a general standard antenna into my front-end of the receiver to see the match performance between antenna and LNA.
I have checked some references, it seems HFSS cannot simulate the active circuits (am I right?). So...
Hi,
I want to use balun to get a differential input, but when I add it into the schmetic, there is always the netlist error from the component ideal-balun. The simulation cannot continue.
Does anybody know how to set up the ideal-balun in cadence?
B.R.
Thanks!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
