raman00084
Full Member level 6
i am having xbee2 module, my aim is to transmit serial data wirelessely. i am using xbee in transparent mode.
i am having a pic micro 18f25k22 that operates in 3.3v . now i am printing a serial message "testing xbee" this is done if connect to hyperteminal i can see this. now i connected the tx terminal of pic to D-IN terminal of xbee, on another side of xbee i recive the data in D-OUT Pin of xbee and convert to rs232 and connected to pc hyperterminal but i cannot able to see the " testing xbee " the hypertimanal is blank with some junk characters no data
my baudrate is 9600
kindly tel me how to proceed is there is any configuration settings for xbee?
kindly help
regards
kalyan
i am having a pic micro 18f25k22 that operates in 3.3v . now i am printing a serial message "testing xbee" this is done if connect to hyperteminal i can see this. now i connected the tx terminal of pic to D-IN terminal of xbee, on another side of xbee i recive the data in D-OUT Pin of xbee and convert to rs232 and connected to pc hyperterminal but i cannot able to see the " testing xbee " the hypertimanal is blank with some junk characters no data
my baudrate is 9600
kindly tel me how to proceed is there is any configuration settings for xbee?
kindly help
regards
kalyan