Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

why aluminium is used instead of copper in ic fabrication

Status
Not open for further replies.

rakesh1234

Member level 5
Member level 5
Joined
Dec 12, 2006
Messages
93
Helped
13
Reputation
26
Reaction score
7
Trophy points
1,288
Activity points
1,872
can anybody tell me why aluminimium is used until now in ic fabrication for metal layers insted of copper in spite copper has low resistance and now they have move back toward to copper
 

Re: why aluminium is used instead of copper in ic fabricatio

hello rakesh


your ans is that cu has less res than al now a days cu introduce in fabs b'coz to kept delay low now a days the capacitance becomes increases so we have to reduces the resistance.

ok.
 

    rakesh1234

    Points: 2
    Helpful Answer Positive Rating
the idea is that Cu diffuse into Si and oxide , so u need some barrier to use Cu, also Cu is easily oxidized also u have to use additive technique to use Cu interconnects like single or double damascence "cause u cannot RIE the Cu"

Added after 1 minutes:

however i think modern echnology tends to use Cu and try to use some techniques to overcome the difficulties in using it
 

    V

    Points: 2
    Helpful Answer Positive Rating
Re: why aluminium is used instead of copper in ic fabricatio

copper diffuses into Si, so you have to put a barrier layer to prevent that (usually TiN)
and after polishing for the surface of copper, another layer is put to totally encapsulate the copper
this technique is called Damascene (taken from the name of the city of damas, the capital of Syria, since they do many metal carvings there)

for aluminium,it also has the diffusion problem for temperatures more than 450° (spiking) and another problem:electromigration
for the first problem, Al can be replaced by AlSi
for the second problem, AlCu can be used and to prevent diffusion then a barrier layer of TiN is used
 

    V

    Points: 2
    Helpful Answer Positive Rating
Re: why aluminium is used instead of copper in ic fabricatio

Electro migration is the major disadvantage of Aluminum

yash
 

what is the differance between lattice diffusion and grain boundary diffusion in metals, while undergoing electromigration.another question,can electromigration take place in semiconductorsb also?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top