Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

virtex-5-EDK - mb_opb - reg

Status
Not open for further replies.

vinodkumar

Full Member level 5
Joined
Oct 5, 2006
Messages
251
Helped
12
Reputation
24
Reaction score
3
Trophy points
1,298
Location
hyderabad
Activity points
2,822
hello all,
I am using virtex 5SX35T custom board in which i want to use microblaze for UART communication and protocol.
even if i am writing simple code..it is not seen in hyperterminal...

here is the code:
#include "xparameters.h"

#include "stdio.h"

#include "xutil.h"

int main (void)
{

// int input;

while(1)
{
xil_printf("my name is Xyz");
}
}

pls help me out i am not seing any error in XPS procedure.
i am getting warning like:

WARNING:MDT - H:\vinod\EDK\rs232_rx\rs232_tx_rx.mhs line 83 - No Driver Found
for instance mb_opb. To avoid seeing this warning, assign the appropriate
driver or driver "generic 1.00.a " to instance mb_opb

can this be a problem for communication establishment....

regards,
vinod kumar.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top