vinodkumar
Full Member level 5
hello all,
I am using virtex 5SX35T custom board in which i want to use microblaze for UART communication and protocol.
even if i am writing simple code..it is not seen in hyperterminal...
here is the code:
#include "xparameters.h"
#include "stdio.h"
#include "xutil.h"
int main (void)
{
// int input;
while(1)
{
xil_printf("my name is Xyz");
}
}
pls help me out i am not seing any error in XPS procedure.
i am getting warning like:
WARNING:MDT - H:\vinod\EDK\rs232_rx\rs232_tx_rx.mhs line 83 - No Driver Found
for instance mb_opb. To avoid seeing this warning, assign the appropriate
driver or driver "generic 1.00.a " to instance mb_opb
can this be a problem for communication establishment....
regards,
vinod kumar.
I am using virtex 5SX35T custom board in which i want to use microblaze for UART communication and protocol.
even if i am writing simple code..it is not seen in hyperterminal...
here is the code:
#include "xparameters.h"
#include "stdio.h"
#include "xutil.h"
int main (void)
{
// int input;
while(1)
{
xil_printf("my name is Xyz");
}
}
pls help me out i am not seing any error in XPS procedure.
i am getting warning like:
WARNING:MDT - H:\vinod\EDK\rs232_rx\rs232_tx_rx.mhs line 83 - No Driver Found
for instance mb_opb. To avoid seeing this warning, assign the appropriate
driver or driver "generic 1.00.a " to instance mb_opb
can this be a problem for communication establishment....
regards,
vinod kumar.