fighter
Junior Member level 1
Hey,everybody,i'm suffering by useing chipscope ,would you like to
show me some suggestions with my appreciation!
my enviorment:
1,fpga :virtexII xc2v3000
2,eda tool: ise5.1
3,chipscope :4.1i or 5.2
I want to use chipscope to capture some signals from my fpga,
but i cannot configure fpga with chipscope corretly,the below
messages display :
configure failed,done pin is low!!!
i'm not sure the true reason,because i can configure fpga with impact
correctly(jtag mode),so the jtag chain interface should be ok,
Plus i got some information from xilinx website,that chipscope5.2pro is
designed to work with ise5.2,and chipscope5.1 is designed to work with
ise5.1,the same reason,so chipscope4.1 is designed to only work with
ise4.1????is it right?
For i have chipscope4.1 and chipscope5.2
and i have ise4.2 and ise5.1.
What your suggestion about compatibility between ise & chipscope???
Thanks a lot!!!!
show me some suggestions with my appreciation!
my enviorment:
1,fpga :virtexII xc2v3000
2,eda tool: ise5.1
3,chipscope :4.1i or 5.2
I want to use chipscope to capture some signals from my fpga,
but i cannot configure fpga with chipscope corretly,the below
messages display :
configure failed,done pin is low!!!
i'm not sure the true reason,because i can configure fpga with impact
correctly(jtag mode),so the jtag chain interface should be ok,
Plus i got some information from xilinx website,that chipscope5.2pro is
designed to work with ise5.2,and chipscope5.1 is designed to work with
ise5.1,the same reason,so chipscope4.1 is designed to only work with
ise4.1????is it right?
For i have chipscope4.1 and chipscope5.2
and i have ise4.2 and ise5.1.
What your suggestion about compatibility between ise & chipscope???
Thanks a lot!!!!