abishek007
Junior Member level 3
Hi All,
I am stuck with my project... I have a tester equipment which can communicate with the board using RS232 . But the board can connect to the the PC using USB connection or RS232.
Problem:-
Need to change the RS232 connections every time i need to reset the board. ( connect it to PC reset the board.. after it connect it to tester and continue test)
I need to automate this part in my project...
Solution 1:- Build a UART switch and toggle between 2 RS232 connections.
Solution2 :- Connect the tester to my PC and change the RS232 commands to USB and pass it to the board.
I am more interested in solution 2 but have no Idea how to work it out..
I would really appreciate for your reply on this ASAP,
Thanks,
-Abishek
I am stuck with my project... I have a tester equipment which can communicate with the board using RS232 . But the board can connect to the the PC using USB connection or RS232.
Problem:-
Need to change the RS232 connections every time i need to reset the board. ( connect it to PC reset the board.. after it connect it to tester and continue test)
I need to automate this part in my project...
Solution 1:- Build a UART switch and toggle between 2 RS232 connections.
Solution2 :- Connect the tester to my PC and change the RS232 commands to USB and pass it to the board.
I am more interested in solution 2 but have no Idea how to work it out..
I would really appreciate for your reply on this ASAP,
Thanks,
-Abishek