wakaka
Full Member level 4
Hi all, I would like to do a project using PIC and a TV remote controller(Sony, panasonic,JVC.....)
Wat i wan is,
if '1' is pressed, Pin_B0 ==1, else Pin_B0 ==0
if '2' is pressed, Pin_B1 ==1, else Pin_B1 ==0
something like the above.
Is there any recommended schematic, IR decoder or receiver for particular remote control?
how to read the output from the receiver module and perform specific task?
Thanks.
Wat i wan is,
if '1' is pressed, Pin_B0 ==1, else Pin_B0 ==0
if '2' is pressed, Pin_B1 ==1, else Pin_B1 ==0
something like the above.
Is there any recommended schematic, IR decoder or receiver for particular remote control?
how to read the output from the receiver module and perform specific task?
Thanks.