Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Trace Impedance Control with Component

Status
Not open for further replies.
A

azim.roslan

Newbie level 4
Joined
Feb 1, 2011
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Malaysia
Activity points
1,307
Hello Guys,

I got some issues here about how to design a trace to get 50 Ohm impedance control.

Lets say i have 1 trace, start from point A and ended at point B. The trace impedance is 50 Ohm. Then, i put component (capacitor or inductor) on the trace line. The impedance control should not be 50 Ohm anymore (correct me if i'm wrong). How to get 50 Ohm impedance control on that situation? Please refer attached pic.

58_1297737569.jpg
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top