alan6449
Advanced Member level 4
fmcw design
hi there..i need to design fmcw radar for rf part ( transmiiter and receiver).where can i get information rf part design and analysis for fmcw...below is paramater for design
Objective:
To design and construct a polarimetric FMCW Imaging System. The proposed system should have the capability to measure the complex scattering matrices of distributed targets using FMCW system and produced a two dimensional image for the field measured.
System Parameter Design Considerations
System configuration FM-CW
Operating frequency C-band (5.3 GHz)
Measurement range 20 to 100m
s° dynamic range +20dB to –40dB
Signal Processor PC-based system
Sweep bandwidth, B 400MHz
Operating platform Ground based
i hope u alll can guide plz...urgent...
regards
alan
hi there..i need to design fmcw radar for rf part ( transmiiter and receiver).where can i get information rf part design and analysis for fmcw...below is paramater for design
Objective:
To design and construct a polarimetric FMCW Imaging System. The proposed system should have the capability to measure the complex scattering matrices of distributed targets using FMCW system and produced a two dimensional image for the field measured.
System Parameter Design Considerations
System configuration FM-CW
Operating frequency C-band (5.3 GHz)
Measurement range 20 to 100m
s° dynamic range +20dB to –40dB
Signal Processor PC-based system
Sweep bandwidth, B 400MHz
Operating platform Ground based
i hope u alll can guide plz...urgent...
regards
alan