kender
Advanced Member level 4
mosfet for 200khz switching
Colleagues,
Newbie to the power electronics here. I need to design a switch that will connect a 200kHz signal with 600W 2% duty power to a load resistor. The switch will connect the load resistor for a 100us at most. The initial signal comes from the unbalanced source to a hand-wound balun, so the voltages are flexible.
Could you point me to topologies for such switch?
Thanks,
- Nick
Colleagues,
Newbie to the power electronics here. I need to design a switch that will connect a 200kHz signal with 600W 2% duty power to a load resistor. The switch will connect the load resistor for a 100us at most. The initial signal comes from the unbalanced source to a hand-wound balun, so the voltages are flexible.
Could you point me to topologies for such switch?
Thanks,
- Nick