analog_chip
Full Member level 1
Hi,
I want to use ADS linecalc for designing a coplanar wave guide on a PCB but the vendor website tells only this :
2-Layers, FR-4, 0.062", 1 oz. cu. plate
Where do i get substrate parameters? If I plug in values for FR4 from wikipedia , will it work. Doesn't they vary from manufacturer to manufacturer?
I want to use ADS linecalc for designing a coplanar wave guide on a PCB but the vendor website tells only this :
2-Layers, FR-4, 0.062", 1 oz. cu. plate
Where do i get substrate parameters? If I plug in values for FR4 from wikipedia , will it work. Doesn't they vary from manufacturer to manufacturer?