mshh
Full Member level 6
i have leadshine stepper motor driver dm542e "2-phase stepper motor drive to control stepper motor . but i have problem in Dip selection switch. choosing different compination of the Dip leads to hot motor and noise with difficult motion. so i think there is a special configuration. i use power supply 10 A
my stepper motor specs is mentioned in the first post , its model
Stepper Motor (NEMA 23) 57HZ54-09 8 wires
i tried the series and parallel connections. it is connected parallel now
the motor make a sound tic tic and the shaft doesn't move , sometimes it moves and sometimes tic tic. i want to know how to choose the Dip switch
it's hot i can't hold my hand more than 5 seconds, is this normal. i measured coils ohm it is 2 ohms connected in series
my stepper motor specs is mentioned in the first post , its model
Stepper Motor (NEMA 23) 57HZ54-09 8 wires
i tried the series and parallel connections. it is connected parallel now
the motor make a sound tic tic and the shaft doesn't move , sometimes it moves and sometimes tic tic. i want to know how to choose the Dip switch
it's hot i can't hold my hand more than 5 seconds, is this normal. i measured coils ohm it is 2 ohms connected in series