Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HI I am doing an RC circuit simulation. For transient analysis,,,I would like to simulate capacitor voltage for different input voltage.
I am using a dc sweep, but it's not functioning.
Like suppose if i want to vary V1 from 30 to 42V than any command?
HI I am doing an RC circuit simulation. For transient analysis,,,I would like to simulate capacitor voltage for different input voltage.
I am using a dc sweep, but it's not functioning.
Like suppose if i want to vary V1 from 30 to 42V than any command?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
