Fengwei
Newbie level 5
Hi.
I am suffering from a lot of DRC errors of Metal1 in P&R of ICC.
Calibre reports a lot of DRC errors while ICC doesn't report any error.
Total number of DRCs = 0
The main errors in Calibre are for Metal 1.
These are adjacent edges, spacing, minarea, spacing of VIA1.
I checked the tf file. The definitions for these parameters are correct.
What is the problem? Can anybody give me some suggestions?
I am suffering from a lot of DRC errors of Metal1 in P&R of ICC.
Calibre reports a lot of DRC errors while ICC doesn't report any error.
Total number of DRCs = 0
The main errors in Calibre are for Metal 1.
These are adjacent edges, spacing, minarea, spacing of VIA1.
I checked the tf file. The definitions for these parameters are correct.
What is the problem? Can anybody give me some suggestions?