SMPS Transformer in Push Pull configuration

[engr.waqas]

Hi
Can anybody provide me a link describing a step by step guide on how to design an SMPS transformer in push pull configuration? I'm stuck in selecting right size of ferrite core .
If you don't know the link but have required formulas please let me know.

Regards
Waqas Shafique

 

[goldsmith]

Hello my friend!
See below please:
https://www.edaboard.com/threads/229615/
Good luck
Goldsmith

 

[ea.arun]

shall refer the transfomer design part of this app note.....

https://www.ti.com/lit/an/slua053/slua053.pdf

Regards,
EA

 

[engr.waqas]

@gold smith : Hi thanks a lot for this sharing. Is your calculations for push pull type too?

---------- Post added at 10:47 ---------- Previous post was at 10:46 ----------

@ea_arun: Thanks allot, it seems you have solved my issue, I'll read it in detail and will let you know.

 

[goldsmith]

Dear Friend
You can calculate all of the SMPS transformers with that .
Best Lucks
Goldsmith

 

[engr.waqas]

Oh thanks. let me read in detail.

Regards
Waqas Shafique