Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Small problem on Network...

Status
Not open for further replies.
subbuindia

subbuindia

Member level 5
Joined
Dec 13, 2011
Messages
87
Helped
11
Reputation
22
Reaction score
10
Trophy points
1,288
Location
Vellalacheruvu(AP), India
Activity points
1,908
Hi friends...
New Bitmap Image.jpg
Find out the currents i1 and i2 for the circuit....?
 

when batteries are in parallel. in theoretical their voltages should be equal. Here, only either I1 or I2 exists which is 1A. when the driving battery looses it's charge and reduces it's voltage, other battery drives both load and another battery(then current depends on the voltage of the battery who lost it's charge).....
 

malli_1729 said:
when batteries are in parallel. in theoretical their voltages should be equal. Here, only either I1 or I2 exists which is 1A. when the driving battery looses it's charge and reduces it's voltage, other battery drives both load and another battery(then current depends on the voltage of the battery who lost it's charge).....
Click to expand...

Fine my dear friend.. Here, I'm applying the voltage from RPS. Even, u r saying the current produced by voltage sources are changing.. Is it possible in this circuit..? That is, if i1= 0A then i2=1A, but how it change immediately..? I knew, the current flowing through resistor is 1A, but i didn't get the values of i1 and i2..
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top