mohamis288
Full Member level 3
Hello,
I am simulating a simple test circuit including RFpulsed generator in ADS. but the simulation gave some surprising result. I have attached my test circuit schematic in the attachment. moreover, I have added the simulation plot there. pay attention to the output resistor value of the RFpulsed generator. I have a couple of questions as in the following:
1- the output voltage value of RFpulsed generator probe (vin) is not correct as per its output resistor. what do you think?
2- I have applied a time delay of 50 usec at the beginning and the start time of simulation is 0 sec. the stop time of simulation was set 100 nsec. so, nothing should have been shown in the simulation result. what do you think about?
3- when I want to do transient simulation without the DC supply, while I have the RFpulsed generator, I encounter with an error. what do you think about the reason?
best regards,
thank you
I am simulating a simple test circuit including RFpulsed generator in ADS. but the simulation gave some surprising result. I have attached my test circuit schematic in the attachment. moreover, I have added the simulation plot there. pay attention to the output resistor value of the RFpulsed generator. I have a couple of questions as in the following:
1- the output voltage value of RFpulsed generator probe (vin) is not correct as per its output resistor. what do you think?
2- I have applied a time delay of 50 usec at the beginning and the start time of simulation is 0 sec. the stop time of simulation was set 100 nsec. so, nothing should have been shown in the simulation result. what do you think about?
3- when I want to do transient simulation without the DC supply, while I have the RFpulsed generator, I encounter with an error. what do you think about the reason?
best regards,
thank you