Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Set up for the calibration of ESD target

Status
Not open for further replies.
A

ammassk

Member level 2
Joined
Jul 19, 2012
Messages
43
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,606
dear all

We are trying to set up a calibration procedure for the measurement of transfer Impedance of ESD Target. For this we are following the IEC 61000-4-2 edition 2 Standard. This procedure is based on the set up given in this standard. In the set up, a current source is given at the input side which gives the current to the target . Here I kindly request you to give guidance for the selection of this current source for the calibration. Which specification we have to use for the same.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top