[SOLVED] set up corners cadence gPDK 45nm

[yardum]

I have followed the guide here

https://wikis.ece.iastate.edu/vlsi/index.php/Corner_Simulations_using_ADE_XL

however I'm getting many errors like this one:

Error found by spectre during circuit read-in.
    ERROR (SFE-59): "/Cadence/gpdk045_v_5_0/models/spectre/gpdk045_mos.scs" 230: Cannot run the simulation because parameter →xn′hasalreadybeendef∈ed.Toallowduplicateparameterdef∈itions,setthevalueof
' role="presentation">→xn'hasalreadybeendef∈ed.Toallowduplicateparameterdef∈itions,setthevalueof→xn′hasalreadybeendef∈ed.Toallowduplicateparameterdef∈itions,setthevalueofredefinedparams' to ignore′or' role="presentation">ignore'orignore′orwarning' in the netlist to consider the parameter defined later. Next, rerun the simulation.

Please could you describe how to setup corners for this kit.

--- Updated Feb 22, 2024 ---

seems to run if nominal corner is deselected. not sure why the option is there if it messes things up.