anbudroid
Newbie
I try to build my simple Arduino based buck boost convertor . to do this I draw a basic schematic diagram In proteus 8.6 and try to run in simulation mode. but whenever I run with schottkey diode it thrown an error " no model specified for D1 , partition error". without D1 simulation works. I tried all the available schottkey models in proteus library.
I googled then found model for D1 (schottkey) is not found in library. but don't know how to add models for components.
- - - Updated - - -
anyone here knew's schottkey library for proteus or how to create schottkey component for simulation in proteus .
I googled then found model for D1 (schottkey) is not found in library. but don't know how to add models for components.
- - - Updated - - -
anyone here knew's schottkey library for proteus or how to create schottkey component for simulation in proteus .