privas
Junior Member level 3
rpm counter pic
I have a machine that twist metal square tubes. It makes a spiral turns into the tubes to make them more decorative. Problem is that I have to count the turns myself and then manually turn off the machine. I would like to make or buy a device that would turn off the machine after 10 turns. The machine completes 14 turns in about 90 seconds. The machine operates on 110 volts and has a basic on/off switch.
Any ideas or suggestions?
I have a machine that twist metal square tubes. It makes a spiral turns into the tubes to make them more decorative. Problem is that I have to count the turns myself and then manually turn off the machine. I would like to make or buy a device that would turn off the machine after 10 turns. The machine completes 14 turns in about 90 seconds. The machine operates on 110 volts and has a basic on/off switch.
Any ideas or suggestions?