pwq1999
Member level 2
i creat rpm according to the software guide:
1. During synthesis,I/O insertion and the Creation of I/O Pads from Ports are disabled.
2.run floorplanner
3,After all of the components placed ,select File -> Write RPM to UCF.(i create ucf file and ngc file)
but when i instantiate the rpm, the relationally locations are change, can anyone help me out, thanks in advance!
1. During synthesis,I/O insertion and the Creation of I/O Pads from Ports are disabled.
2.run floorplanner
3,After all of the components placed ,select File -> Write RPM to UCF.(i create ucf file and ngc file)
but when i instantiate the rpm, the relationally locations are change, can anyone help me out, thanks in advance!