Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with philips TV,help plz...

Status
Not open for further replies.
N

Naw_S

Member level 2
Joined
Jan 6, 2006
Messages
47
Helped
13
Reputation
26
Reaction score
0
Trophy points
1,286
Activity points
1,681
i'm repairing an old philips tv with chassis cto-90 and getting some problem.the right side to the middle of the screen is ultra bright while the left side is ok,there was some bad capacitor in the vertical section,i change and get same prob,can anyone plz help.
 

can anyone plz help,at least tell me in what section i must check.
 

Hi, this fault is common in old TV sets. This may be caused by ripple in the power supply (around 200V) of RGB output circuit. Look for dried up caps around CRT neck. These caps are usually rated 4.7-10uF, 200V. Also check the small caps around FBT. Small caps are hard to check so use a capacitance meter. Goodluck!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top