Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

possitive power plane in pads

Status
Not open for further replies.
S

srinims

Newbie level 5
Joined
Apr 8, 2009
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
bangalore
Activity points
1,326
Hi,
In the pads 2007 how to make a possitive power plane. Please tell me step by step.. I am new to pads.
Regards,
Srinivas.
 

Hi,

Go to Setup --> Layer Definition --> click the layer --> in plane type select Split/Mixed --> then assign the nets (GND, PWR net names) --> ok

Hope this helps you.

Thanks,
Ahar..
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top