vijaimvk
Newbie level 5
I am Using HFSS 9.2
This is my 3D radiation pattern
Hence I expect figure of 8 in XZ plane and circle in XY plane
for x plane i followed the steps as shown in below pictures.
But not getting proper result...
For XZ plane
Changed angle as theta,
Under Sweeps tab selected Phi=0,
If this is wrong ..plz suggest corrections
This is my 3D radiation pattern
Hence I expect figure of 8 in XZ plane and circle in XY plane
for x plane i followed the steps as shown in below pictures.
But not getting proper result...
For XZ plane
Changed angle as theta,
Under Sweeps tab selected Phi=0,
If this is wrong ..plz suggest corrections