Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Please help in LabVIEW

Status
Not open for further replies.

Wacas

Newbie level 5
Newbie level 5
Joined
May 18, 2008
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,335
I want to send two bit data through parallel port using labview to my external circuitry....Please tell me how to do this,if you could send me the code i would really appreciate that,Thnx a lot.
 

try thisone: **broken link removed**

If you cannot work it out I will create a VI for you. I did not create it because I wanted you to learn LabVIEW yourself....

enjoy talking G.
 

Thanks A lot..i try it myself
 

I tried i myself but facing few problems,i have four buttons and want to send a unique two bit data to my parallel port through these buttons, plz make a VI for me,Thanx
 

Use the Out Port.vi and In Port.vi to write and read from parallel port. Address you need to specify based on the part you have. The attached VI will give a basic idea for you.

..
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top