falcon026
Newbie level 6
my AT89c5131 is being properly detected by FLIP via usb , after applying hardware conditions via board ... but this is only when 8Mhz oscillator is used in the circuit
when i replace 8Mhz by 11.0592Mhz , the microcontroller is not detected after applying hardware conditions.
whenever i need my board to be detected i have to insert 8Mhz, and then after programming flash, if i replace oscillator with 11.0592Mhz then it works fine n according to 11.592Mhz.
The problem is in detection when oscillator is not 8Mhz ... so what to do ?
when i replace 8Mhz by 11.0592Mhz , the microcontroller is not detected after applying hardware conditions.
whenever i need my board to be detected i have to insert 8Mhz, and then after programming flash, if i replace oscillator with 11.0592Mhz then it works fine n according to 11.592Mhz.
The problem is in detection when oscillator is not 8Mhz ... so what to do ?