shruv
Member level 2
hello,
I went through the previous posts but still haven't found how i can rectify the error.
I am using at89s52 controller.Is their any difference between avr controller and at89s52 controller?
I am using progisp programmer,when I click on read device,I get " Chip Enable Program Error" why am I getting this error? what do I need to do to correct it?
Can I create the hex file using keil software and the load it using progisp?
If not keil which software do I require to write and compile the program?
I went through the previous posts but still haven't found how i can rectify the error.
I am using at89s52 controller.Is their any difference between avr controller and at89s52 controller?
I am using progisp programmer,when I click on read device,I get " Chip Enable Program Error" why am I getting this error? what do I need to do to correct it?
Can I create the hex file using keil software and the load it using progisp?
If not keil which software do I require to write and compile the program?