Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i am expected to use sort of an analog mux circuit to switch between the two. any idea how i can do that with a 4051 mux? i don't know much about how to set the time intervals when the mux circuit reads between the two.
I could not see the break before make switching delay time for a CD4051 on its datasheet. Circuits with it usually bias the output at half the analog supply voltage so during the delay time the signal goes half-way.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.