akchetana
Newbie level 5
Hello all,
I am working on an SRAM cell for which I have to perform monte-carlo simulation.
During MC simulation in ADEXL window, we found a pop up window with the following error messages after 10 min, while the 6T SRAM cell was run for 100ns for 2 samples. Please help in this matter.
[Error message
ADEXL-1921: failed to start new job after 3 attempts . Possible reasons could be
1. The macnie selected in the current job set up policy is not reachable
2. The cadence hierarchcy is not detectedd, not installed properly, or not compatible on the machine selected in the current job set up policy.
3. Job start script /home/student/chetna/.temp_student/.cmddir0/runICPR3 is not found in the remote machine.
Do you want to retry with the current set up? Selecting no will abort the current session. ]
However it is working when we try to simulate using .ocn script.
Thanks.
I am working on an SRAM cell for which I have to perform monte-carlo simulation.
During MC simulation in ADEXL window, we found a pop up window with the following error messages after 10 min, while the 6T SRAM cell was run for 100ns for 2 samples. Please help in this matter.
[Error message
ADEXL-1921: failed to start new job after 3 attempts . Possible reasons could be
1. The macnie selected in the current job set up policy is not reachable
2. The cadence hierarchcy is not detectedd, not installed properly, or not compatible on the machine selected in the current job set up policy.
3. Job start script /home/student/chetna/.temp_student/.cmddir0/runICPR3 is not found in the remote machine.
Do you want to retry with the current set up? Selecting no will abort the current session. ]
However it is working when we try to simulate using .ocn script.
Thanks.