wtr
Full Member level 5
Hello all,
So I'm aware how to turn off certain warnings for example (NumericStdNoWarnings = 1.)
However I would like to know how I can change the text color? If at all possible.
I'm triggering modelsim 10.6 by running the following command in Linux red hat ksh terminal, my environment variable for TERM = xterm (which enables colour modes with vim)
vsim -c
Once in the console window I like to run various command like
vcom -93 -work mylibrary my_file.vhd
However the console just displaces plain old text. I was hoping there is a way I could get the error messages to display in colour. <similar to how git informs the use of status>
I've looked through the tcl command book with keyword "color" - it mostly relates to gui aspects like configuring the wave pane.
When in gui mode the transcript window is coloured, so essentially I'm hoping the same is possible in console mode.
Regards,
Wes
So I'm aware how to turn off certain warnings for example (NumericStdNoWarnings = 1.)
However I would like to know how I can change the text color? If at all possible.
I'm triggering modelsim 10.6 by running the following command in Linux red hat ksh terminal, my environment variable for TERM = xterm (which enables colour modes with vim)
vsim -c
Once in the console window I like to run various command like
vcom -93 -work mylibrary my_file.vhd
However the console just displaces plain old text. I was hoping there is a way I could get the error messages to display in colour. <similar to how git informs the use of status>
I've looked through the tcl command book with keyword "color" - it mostly relates to gui aspects like configuring the wave pane.
When in gui mode the transcript window is coloured, so essentially I'm hoping the same is possible in console mode.
Regards,
Wes