kender
Advanced Member level 4
pcb routing bit sizes
Folks,
What end-mill diameters fabs typically used for routing (milling) the outline of the PCB?
I have a PCB with an inside angle. I don't want to make an inside chamfer, as in the bottom-right drawing below. That would weaken the board mechanically. Instead, I want to make an outside chamfer on a mechanical part that mates with that inside angle. It doesn't need to be a close fit. I just want to have a sufficient chamfer radius on the mechanical part.
- Nick
**broken link removed**
Folks,
What end-mill diameters fabs typically used for routing (milling) the outline of the PCB?
I have a PCB with an inside angle. I don't want to make an inside chamfer, as in the bottom-right drawing below. That would weaken the board mechanically. Instead, I want to make an outside chamfer on a mechanical part that mates with that inside angle. It doesn't need to be a close fit. I just want to have a sufficient chamfer radius on the mechanical part.
- Nick
**broken link removed**