MicroChip PIC to Ethernet

[crashed]

microchip pic ethernet

Hi all,

I am looking at writing some software for the PIC18C658 PIC as supplied by MicroChip. I have been trying to work out how to get ethernet with it when I came across these forums.

I have been considering using the Realtek RTL8019AS Single Chip Ethernet Controller/Transciever but am unsure as to connecting this to the PIC as it seems to have an ISA bus.

Can anyone here help me, it doesn't have to be the Realtek controller but does have to be a PIC in the Microchip pic18x family. Just a sample schematic on connecting it would be fine, I can write any code required....

Thanks in advance

 

[C-Man]

pic ethernet microchip

Most (if not all) of this has already been done in Micochip Picdem.net.

Look here:
**broken link removed**

best regards

 

[crashed]

microchip ethernet

Hi,

I have noticed this but I cannot justify the cost as all I require is a schematic or details of the pins to use between the Ethernet Controller and the PIC. My knowledge of electronics however prevents me from doing this as there are over 100 pins on the Realtek controller.

Can anyone provide me with this?

Thanks

 

[crashed]

pic to ethernet

Sorted it

The Schematics are in Appendix A and don't appear in the bookmarks. Does the RTL8019 come pre-programmed or does it need software written to it?

 

[sadat007]

rtl8019 microchip

Hi, Realtek RTL8019AS not preprogramed 8)

Try to find out old ISA Realtek RTL8019AS card use its components.
And request free PIC18xxxx from microchip.

 

[cube007]

pic ethernet

Hello crashed,

you can get information about a complete (schematic, layout, ...) projekt with PIC16F877 from this website: **broken link removed**

All the information is in German. I hope it will help you.

by,
cube007

 

[C-Man]

pic ile ethernet

For connection of an ISA network card check this:
**broken link removed**

best regards

 

[crashed]

pic com ethernet

Hi, Realtek RTL8019AS not preprogramed

Try to find out old ISA Realtek RTL8019AS card use its components.
And request free PIC18xxxx from microchip.

Any idea on where I can get the Firmware for this??? And type of programmer????

 

[tjalps]

using udp microchip

Hello!

Beside Realtek IC you will still need TCP/IP stack, wich is wery hard to make. Maybe you can try folowing solutions:

1 EPSON S1S60000 www.epson.com
2 BECK-IPC www.beck-ipc.com

Regards!

 

[ME]

pic18 with rtl8019+schematic

Look in this book:
TCP/IP lean Second edition
www.elektroda.pl/eboard/viewtopic.php?t=43694
Go to page two in the topic to download the book.

 

[dainis]

rtl8019 + pic cards

Links, PIC and Ethernet ...

http://www.davidwitt.ca/
**broken link removed**
http://jmandon.free.fr/ne2000/ne2000.htm

 

[bluecube]

ethenet microchip

If you just want to connect to ethernet easily without writing tons of code to support TCP/UDP protocol stack - take a look at LANTRONIX XPORT.

All you need is serial interface port without the transceiver and interface
to that unit. The Lantronix comes with an RJ-48 and a 80186 CPU all
build into a RJ48 socket. The performance is not that great, but then
who cares if you're using a PIC uproc

 

[crashed]

pic ethernet ebook download

Thanks, I'll look at that in the morning...