Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

max3232 to OR gate driving an LED

Status
Not open for further replies.

popoyboys

Advanced Member level 4
Full Member level 1
Joined
Feb 20, 2007
Messages
110
Helped
4
Reputation
8
Reaction score
2
Trophy points
1,298
Location
from the deepest roots of KAMOTE land
Activity points
1,967
Hi,

I would like to seek your advice on this circuit.

What are the challenges you think would arise from this circuit?
Any suggestions for improvement?

2ensrb7.png
 

Attachments

  • max3232.png
    max3232.png
    10.7 KB · Views: 92
Last edited:

I'm not sure what you mean by 'challenges' but assuming the rest of the circuit is present and correct, there are some things to be aware of:

1. The OR gate and LED must both be capable of working from a 3.3V supply.
2. You must limit the current that could flow through the LED by adding a resistor in series with it.

Brian.
 

And OR gate output must be capable of driving LED (current).
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top