[SOLVED] LVS doesn't recognize triple well devices

[dinos7]

Hi guys!
When i copy the layout of the triple well mosfet nfet33tw from the pdk (ibm 130nm) as it is and ran lvs on this single device without any modification or connections, the calibre is unable to recognize the device. Am i missing anything here?
Thanks

 

[dick_freebird]

Might check that it isn't being "pruned" for lack
of meaningful connectivity.

 

[Dominik Przyborowski]

Check this thread

 

[dinos7]

Might check that it isn't being "pruned" for lack
of meaningful connectivity.

I made meaningful connectivity and still it had the same issue. Then I found there was layer that i forgot to draw to make LVS extract the net33tw device. now it is working fine. thanks!

Check this thread

Thanks Dominik!, it helped me solving subc mismatch between layout and schematic.