Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

In cadence, how to resimulate the transient simulation from the point of completion?

M

mssong

Newbie level 5
Joined
Jul 25, 2023
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
89
I ran cadence's transient simulation for 1s and got the waveform.

Is it possible to run the simulation for only 1 second, starting from the part of the simulation (1s) and ending at (2s), without simulating the previous part (1s)?
 
Solution
D
In the transient analysis setup you can save final operating point,
and somewhere in there you can also set an initial condition file
and a start timepoint. You may need to suppress DC initial
condition to force using the tran final OP instead (been a while
since I have done chained tran analyses). It's all in there though.
Sort by date Sort by votes
In the transient analysis setup you can save final operating point,
and somewhere in there you can also set an initial condition file
and a start timepoint. You may need to suppress DC initial
condition to force using the tran final OP instead (been a while
since I have done chained tran analyses). It's all in there though.
 
Upvote 1 Downvote
Solution

LaTeX Commands Quick-Menu:

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top