giorgos3924
Junior Member level 2
Hello i trying to route a WiFi chip (CC3200) with an antenna connector.
i using saturn pcb calculator and i decide to go with coplanar waveguide.
In my research on the internet i found that there's many different layer-stackups from manufacturer to manufacturer
and my problem is i don't know what values to use in my calculator.
Is there something standar (4-layer) which used to to manufacturing?
Thanks!
i using saturn pcb calculator and i decide to go with coplanar waveguide.
In my research on the internet i found that there's many different layer-stackups from manufacturer to manufacturer
and my problem is i don't know what values to use in my calculator.
Is there something standar (4-layer) which used to to manufacturing?
Thanks!