elionidas
Newbie level 5
Hi,
I use EDK 11.1 and To create powerpc processor, I used BSB wizard in XPS and for C code I used the "Add software application project".
The problem is that after doing all steps for programming FPGA (ML507) nothing appear in the HyperTerminal. But when I build the project" TestAppl_MEMORY_ppc440_0 the HT work well !!!!!!!!!
I make my Baud at 9600,stop-bits, parity in XPS for UARTLITE.
Plz any suggestions for my problem
I use EDK 11.1 and To create powerpc processor, I used BSB wizard in XPS and for C code I used the "Add software application project".
The problem is that after doing all steps for programming FPGA (ML507) nothing appear in the HyperTerminal. But when I build the project" TestAppl_MEMORY_ppc440_0 the HT work well !!!!!!!!!
I make my Baud at 9600,stop-bits, parity in XPS for UARTLITE.
Plz any suggestions for my problem