Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Set Timer 2 to 16-bit Auto reload mode ..
se Timer2 interrupt and select a value for RCAP2L/RCAP2H that gives a nice timer "tick" - e.g. 10 ms would give you an interrupt rate of 100/s ..
Then you can count 100 interrupts to get 1/s or as much as you think the response time should be ..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
