wht4665453123
Newbie level 6
Dear all,
I'm using the LSSP analysis in the GoldenGate simulator to design a one-port negative resistance oscillator.
My question is:
What component should be in the circuit schematic as the port?
I tried to use the psin from Analoglib, which was often used for small signal SP simulation, but the LSSP gives error saying that "at least one active port should be defined to run LSSP analysis". I tried changing the psin to the RFPWS component from the GoldenGatelib, but when selecting ports in the simulation manual, it says this object is not valid selection.
I appreciate your help very much.
I'm using the LSSP analysis in the GoldenGate simulator to design a one-port negative resistance oscillator.
My question is:
What component should be in the circuit schematic as the port?
I tried to use the psin from Analoglib, which was often used for small signal SP simulation, but the LSSP gives error saying that "at least one active port should be defined to run LSSP analysis". I tried changing the psin to the RFPWS component from the GoldenGatelib, but when selecting ports in the simulation manual, it says this object is not valid selection.
I appreciate your help very much.