Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
For MCLR pin you have to pullup it using a 10K resistor. Use NPO capacitors between 18 and 33pF. It's value depends of crystal value ... in datasheet has a list of values for each crystal, but the correct is your crystal vendor give you the correct value for that especific crystal ...
take care that the improper capacitor value may cause one of two
1-not accurate timer.
2-the controller may not work.
that is according to the difference between the proper and the improper value
to get the proper value
--check the datasheet of the crystal u will use
h**p://www.microchip.com/stellent/idcplgIdcService=SS_GET_PAGE&nodeId=1490&filterID=414
isn't working.
I can't find datasheet for my 32.768khz crystal
thanks for all help!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.