jegandren
Junior Member level 3
high side mosfet driving
Dear all,
Attached is a circuit to drive a single high side driver, the circuit works fine when the load is not connected to the parallel capacitor (470uF/400V). but when the capacitor is connected in parallel to the load the IR2110 is burnt,
can any one advise on this.
Many thanks
Dear all,
Attached is a circuit to drive a single high side driver, the circuit works fine when the load is not connected to the parallel capacitor (470uF/400V). but when the capacitor is connected in parallel to the load the IR2110 is burnt,
can any one advise on this.
Many thanks